Global bending parameters dialogue box

General special functions (MCM)

No check of the hold-down clamp

Here, the check of whether a counter-bending jaw is present is deactivated. (IGNORE_BLANKHOLDER)

No check of the width of the hold-down clamp

Here, the check is deactivated of whether the hold-down clamp is longer than the bending line. (NO_BLANKHOLDER_CHECK)

Rotator acceleration

The value by which the acceleration of the rotator is to be reduced is entered here. Possible values: 5 to 100. (QSU)

Rotator deceleration

The value by which the deceleration of the rotator is to be reduced is entered here. Possible values: 5 to 100. (QSD)

Tolerance of the centring control in Z

The tolerance of the centring control in Z direction is entered here. (ZPF_TORELANCE)

Number of bends before cleaning the B jaw

Here, you enter the interval after how many bends the bending jaws should be cleaned. (CLEAN_BLADE)

Centring procedure

Here, you enter which centring procedure is to be used. (CENT_FUNC)

Shorten the length of the hold-down tool

The value by which the length of the hold-down is to be shortened in the ROT instruction is entered here. (BLC)

Shorten the length of the hold-down tool

Here, you enter the value by which the length of the hold-down is to be shortened in the BEN instruction. (BLC)

Bending mode

Here, you specify which bending mode is to be applied. Possible values: 0 / 1 / 2. (MODE)

Number of disposal stacks

Here, you enter how many stacks are to be generated if the parts are smaller than 1200 mm in the X direction. Possible values: 0 / 1 / 2. (STACK_POS)