1. PN4000 online help
2. Nesting
3. Separation Cuts
4. Punching
5. Trim sheet
6. Common cut punching parameters dialogue box
7. Base parameters tab

Base parameters tab

Global parameters

Trimming left, top then right

This option causes the trimming to be performed in the specified order.

Trimming right, top then left

This option causes the trimming to be performed in the specified order.

Sheet oversize

Here, you specify how far the machining operation is to be extended beyond the edge of the sheet.

Destroy waste up to

Here, you specify the maximum dimension in the X and Y direction up to which a waste area is to be destroyed. Waste areas that are larger in both directions are not destroyed. This option is always preferred to the Shred waste option.

Shred waste up to

Here, you specify up to which maximum dimension in the X and Y direction a waste area is to be shredded and then disposed of (e.g.via a flap). Waste areas that are larger in both directions are not shredded.

Delete separation cuts on the part hull

This activates that the separation cuts of the parts at the edge of the part hull are deleted.

Tool definitions

Trimming tool

The trimming tool is specified here.

Horizontal separating tool / vertical separating tool

The tool used for each of the horizontal or vertical separation cuts is specified here.

..

This button opens the Tool management dialogue box so that a tool can be selected. See also Dialogue box with tables.

If the button shows "XXXX", then the tool is not available for the current material and thickness and another tool should be selected.

Possibility of disposal

Here, the available disposals are made available for selection. By activating the check box, the respective disposal is activated for use.

Disposal sequence

Here, the priorities are determined with which the disposals are applied.

Change order

This button can be used to change the order of the specified disposals. The Disposal sequencedialogue box opens. See also Disposal sequence dialogue box.