Cut out cutouts dialogue box

Cutout

Maximum width

This specifies the width along the outer contour up to which a cutout is still cut free.

Minimum depth

This specifies the minimum depth in relation to the outer contour at which a cutout is cut free.

Automatic lead-in path

This activates that lead-in paths with the following settings are generated for the separation cuts.

Difference angle of lead-in path

The angle that the lead-in path should have to the cut-off is entered here.

Length of lead-in path

The length of the lead-in path is entered here.

Distance from the contour

Here, you enter the distance that the beginning and the end of the separation cut should have to the contour.

Min separation cut length

Here, you enter the minimum length that the separation line must have in order to generate a separation cut.

Safety distance

Here, you enter the minimum distance that the piercing point of the lead-in path must have to the contour.

Burn ignition hole

The ignition hole is burnt with this option.

Punch ignition hole

The ignition hole is punched with this option.

Punch diameter

The diameter of the punching tool is entered here.

Shred waste

The shredding of the waste is activated here.

Minimum width / minimum height

Here, you enter the minimum dimension in the X or Y direction that a cutout must have in order for the piece to be treated as waste.

Maximum width / maximum height

Here, you enter the maximum dimension in the X or Y direction that a cutout may have in order for the piece to be treated as waste.

Separating grid in X / Separating grid in Y

Here, you enter the grid spacing in the X or Y direction at which the waste is to be shredded.