New path
The New path function can be used to manually reposition the lead-in paths (inner and outer contours) in an NC model. If the lead-in path has a pre-punched hole, this can be selected and the lead-in path repositioned.
This function can be found here:
- Lasering > Change > New path
- Combi > Change > New path
- Nesting > Change > Correction > Lead-in path
Manual repositioning of paths
- Click the New path button.
- The Lead-in path submenu opens. See also Lead-in submenu (1).
- If desired, change the cutting parameters for the paths you want to reposition.
- Use the left mouse button to select the contour where you want to reposition the paths.
- The contour is highlighted in colour.
- Place the paths with the left mouse button.
- Click Close.
- If you want to reposition more paths, repeat steps 2 to 5.
- Click Close.
- The function is ended.
Additional information
