Line with CWP

TASK

Punching along a line with a special tool.

EXECUTION

  1. Editing the tool popup:
    - Four non-rotating tools: The four tools that trim a rectangular part are entered.
    - Two non-rotating tools: Two tools are entered for horizontal and vertical machining.
    - A single rotatable tool: The tool to be inserted trims all sides of the workpiece.
    - Protrusion: Specifies the machining protrusion required to ensure clean processing of the line end.
    - Automatic reduction: The system should automatically retract the protrusion when a collision to an adjacent geometry occurs.
  1. Parameters:
    - Microjoint width: How wide should the microjoint that interrupts the continuous machining be.
    - Minimum length: After what uninterrupted machined length should a microjoint be set.
  1. Selection of the line at which a machining operation must be created.
  1. Selection of the side on which machining is to take place.
  1. Selection of another line (such as 3. and 4.) or terminate the function with Close.

NOTE

See function:

Rectangle with REK