Part data tab
Part
Article
The designation of the current part is displayed here and can be changed.
Archive number
The number of the archive in which the part is stored is displayed and can be changed here.
Number of parts min / max
The minimum or maximum number of parts to be produced is entered here.
Parameters
Mirroring allowed
The release for mirroring the part is given here.
Rotation allowed
The release for the rotation of the part is given here.
Number of increments (1-360)
The number of steps a complete rotation of the part is to be split into is specified here.
Pre-rotation angle
The angle by which the part is to be rotated before it is used for nesting is specified here.
Part is suitable for common cut
This indicates whether the part is suitable for the use of common separation cuts.
Geometry
Display of the current part with dimensions.
Order information
Deadline
The planned date by which the order must be completed is displayed here and can be changed.
Order
The designation of the order of the current part is entered here.
Position
An item description for the part is entered here.
Comment
A comment can be entered here.
Priority
The priority of the job from 1 (high) to 9 (low) is entered here.
Commission
A commission number for the part is entered here.
Disposal
Number of the storage table
The table on which the part is placed during palletising is entered here.
Stack number
The stack on which the part is placed during palletising is entered here.
Attribute
Colour
Here, you can specify the colour in which the part is to be displayed. However, if, for example, commission numbers are assigned, then the part colour is determined automatically in order to distinguish the parts for the commissions.
Post-production of scrap
Here, the part is marked as a post-production of scrap. This information can be output, for example, in the data (job, sheet, or part data).
