Slotted hole parameters dialogue box
Width
The entire width of the hole is entered here. This must be at least as large as the diameter.
Height
The total height of the hole is entered here. This must be at least as large as the diameter.
Diameter
Here, you enter the diameter (double radius) with which the "corners" of the hole are rounded off. At most, this may be as large as the smallest value for height or width.
Distance of the points in X or Y
The distance from hole centre to hole centre in the X or Y direction is entered here.
Length in X direction or Y direction
The length of the grid in the X or Y direction is entered here.
Base angle
The angle between the X axis of the grid and the X axis of the coordinate system is entered here.
Grid angle
The angle between the X and Y axes of the grid is entered here.
Draw inner contours
Here, you can select whether all or only the outermost holes of the grid should be generated.
