Parameters for upper/lower bevel dialogue box
Limit angle for change: bevel cut to I-cut
The limit angle is entered here. All bevel angles less than or equal to the specified angle are set to 0° degrees.
Maximum permitted bevel angle
Here, you enter the maximum angle that is permissible as a bevel angle. All bevel angles greater than the specified angle are reduced accordingly.
Esab change strategy: Bevel cut to I-cut
With this option, bevel cuts with a changing bevel angle are maintained and the bevel angle is only changed to 0° degrees when the specified limit angle is reached or not reached. This option is used as the default when no change strategy is selected.
Microstep change strategy: Bevel cut to bevel cut with limit angle
This option prevents the change from bevel cut to I cut on a contour. A distinction is made between outer contours and inner contours.
Outer contours: For all cuts with bevel angles equal to or smaller than the limit angle, the bevel angle is set to 0° degrees.
Inner contours: For all cuts with bevel angles smaller than the limit angle, the bevel angle is set to the limit angle.
