General parameters tab
Combi common cut strategy
Sort inner contours
Here, you can select how the inner contours are to be sorted: Per part, per group or per sheet.
Sort islands
Here, you can select how the islands should be sorted: Per part, per group or per sheet.
Punch islands
Here, you select which islands are to be punched: Never, rectangular contours, right-angled contours or all contours.
Junctions
Cutouts
Here, you can select whether the junctions should be cut out.
Cutout length
The cutout length is entered here. If the algorithm encounters a neighbouring piece while machining a part, it will be precut at that point by the entered value.
Overlap
The overlap is entered here. When processing a part that has already been partially pre-cut, the laser is not pierced at the exact position where the actual processing must continue, but at a position that has already been processed. The entered value determines by which value the laser is previously pierced.
Junctions with approach path
Here, you can select whether junctions with an approach path are to be generated.
Approach path
The approach path is entered here.
Lasering parameters
Burn ignition hole
Ignition holes are burnt with the laser in this option.
Punch ignition hole
With this option, a hole is punched beforehand at the ignition points of the laser (pre-punch hole).
Lead-in path
The setting of a lead-in path is activated here.
Length of the lead-in path
The length of the lead-in path is entered here.
Vapourise foil
Here, the vapourising of foiled material before processing is activated.
Combine aligned laser machining
Here it can be activated that laser machining with tangential transition, whose machining follows each other, are combined to a single machining.
Delete laser machining outside the sheet
Here you activate that laser machining outside the sheet is deleted.
Trimming
Edge trimming
Here, you can select whether the edge should be trimmed with the laser, by punching or not at all.
Maximum width for trimming
The maximum width for trimming is entered here.
Trimming tool
Dimension in X / Y
The dimension in X or Y direction is entered here.
Dimension in D
The diameter is entered here.
Destruction tool
Dimension in X / Y
The dimension in X or Y direction is entered here.
Dimension in D
The diameter is entered here.
Distances
Cutting kerf
The value for the cutting kerf is entered here.
Nesting distance
The nesting distance is entered here.
Cut contours
Cut outer contour in clockwise direction
Here, you can select whether the outer contour should be cut clockwise.
Cut outer contour counter-clockwise
Here, you can select whether the outer contour is to be cut counter-clockwise.
