Define bending values dialogue box
Bending angle
The bending angle is entered here.
Correction value for bending angle
The correction value for the bending angle is entered here.
Side length
The side length is entered here.
Correction value for side length
The correction value for the side length is entered here.
Bending radius
The bending radius is entered here.
Hold-down width left/total
The width of the left hold-down clamp is entered here.
However, this specification is considered as total width if no width is entered for the right-hand hold-down clamp.
Hold-down width right
The width of the right hold-down clamp is entered here.
Calculate hold-down clamp width
Here, you activate that the width of the two hold-down clamps is calculated using the bending line.
Tool width left (CLA)
The width of the left tool is entered here.
Tool width right (CLA)
The width of the right tool is entered here.
Calculate tool width
Here, you activate that the width of the two tools is calculated using the bending line.
Manipulator speed
The speed of the manipulator is entered here. Entries between 5 and 100 are possible.
