Bending > 1
The Bending > 1 function generates a bending operation whose bending line is specified by 2 points.
Generate bend processing
- The base area of the part is determined. See also Base face function.
- Under Manufacturer > Manufacturer > Salvagnini > Bending, click the Bending > 1 button.
- The Point selection submenu opens. See also Point selection (1) submenu.
- Select a function and enter one after the other:
- the starting point of the bend line
- the end point of the bend line
- the side length of the bend, by selecting a point at the end of the side
- The Execution table dialogue box opens. See also Execution table dialogue box.
- Select the execution table whose deduction values will be used for bending and click OK.
- The Define bend values dialogue box opens. See also Define bending values dialogue box.
- Make your desired settings and click OK.
- If you want to generate further bending operations, repeat steps 2 to 4.
- Click Close.
- The function is ended and the changes are applied.
Additional information
