Salvagnini parameters dialogue box
Width of the holding strip (VAR:T0)
The width of the holding strip is entered here.
Trim claw area later (VAR:T0)
With this option, no trimming takes place, so that the claw area can be processed later with a separate function.
Trim the claw area (VAR:T0)
This option defines the claw area and disposes of it at the end of machining.
Trim sheet (TRI:)
With this option, the sheet is trimmed at the beginning of the machining operations.
Trim sheet and claw area (TRI:+VAR:T0)
With this option, the sheet is trimmed and the claw area is disposed of at the end of machining.
Width of the holding strip from nesting parameters
This activates that the width of the holding strip is determined from the allowed upper edge in the nesting parameters: Minimum 28 mm, maximum 50 mm. See Nesting parameters dialogue box.
