1. PN4000 online help
2. Nesting
3. Extras
4. Reposition
5. Return repo
6. Return repo dialogue box

Return repo dialogue box

Set hold-down manually

With this option, the hold-down is later positioned manually.

Set hold down automatically

With this option, the hold-down is automatically positioned at the lower coordinate.

Min. edge distance

The safety distance to the edge boundaries is entered here.

Hold-down position in X / Y

The X or Y position of the hold-down on the sheet is entered here.

Reference edge of the sheet right / left

Here, you select whether the left edge or the right edge of the sheet is to be the reference edge.

Sheet edge position

The position of the sheet edge after repositioning relative to the reference edge is entered here. The value can be found in the BACKREPO_POSITION table in the MACHINE_PARAM file.TXT (directory: u/pn/machine/machine_xxxx/config).

Limits of the sheet size to set repo

Here, you specify the minimum (from sheet size) or maximum (to sheet size) size of a sheet in the X direction so that a reverse repositioning can be performed.

Set attribute

Here, you select whether an attribute is to be added to the repositioning data set.

Check if a re-repo is necessary

Here, you select whether the reverse repositioning is to be checked. Reverse repositioning does not take place if the first clamping claw overlaps a part that must be disposed of with a stop or the lift.