Cut manual
With the Cut manual function, separation cuts can be generated manually with a cutting operation on the sheet. The separation cuts are automatically limited by the part contours and can be freely positioned and rotated.
This function can be found here:
- Lasering > Extras > Shred waste
- Nesting > Separation cuts > Lasering
Generate separation cuts
- Click the Cut manual button.
- The Separation cut parameters dialogue box opens. See also Separation cut parameters dialogue box.
- Configure your desired settings and click OK.
- Position the separation cut with the left mouse button.
- The provisional separation cut is displayed and dynamically adjusted.
- If you want to rotate the separation cut, click the middle mouse button.
- The separation cut is rotated in the set angular increments.
- Fix the separation cut with the right mouse button.
- If a separation cut with an identical angle already exists at the selected position, the function is cancelled.
- If you want to place more separation cuts, repeat steps 3 to 5.
- Click Close.
- The separation cuts are generated.
Additional information
