Slotted holes tab
Hole type
In this tab, you select the hole type for slotted holes and make the settings for the selected hole type.
Slotted holes in straight rows (Lg)
Lg
Here, you can select the hole type for a slotted hole in straight rows.
Hole length (l)
The hole length is entered here.
Hole width (w)
The hole width is entered here.
Diameter
Enter the diameter for the slotted hole here.
Longitudinal length (c2)
Enter the longitudinal length for the slotted hole here. The longitudinal length is the length in the X direction.
Lateral length (c1)
Enter the lateral length for the slotted hole here. The lateral length is the length in the Y direction.
Angle
The angle for the slotted hole is selected here. You can select 0 or 90 degrees.
Edge distance
The distance to the edge is entered here.
Calculation from the zero point of the selected surface
Position in X/Y
This option is activated if the edge distances in X and Y are to be entered manually.
Centring
This function is activated if the edge distances should be equal.
The hole pattern is centred.
Edge distance X
Here, the edge distance in X is entered. Only a negative margin distance or 0 can be entered. Positive values are not possible.
Edge distance Y
Here, you enter the edge distance in Y. Only a negative margin distance or 0 can be entered. Positive values are not possible.
Slotted holes in staggered rows (Lv)
Lv
Here, you can select the hole type for a slotted hole in staggered rows.
Hole length (l)
The hole length is entered here.
Hole width (w)
The hole width is entered here.
Diameter
Enter the diameter for the slotted hole here.
Longitudinal length (c2)
Enter the longitudinal length for the slotted hole here. The longitudinal length is the length in the X direction.
Lateral length (c1)
Enter the lateral length for the slotted hole here. The lateral length is the length in the Y direction.
Angle
The angle for the slotted hole is selected here. You can select 0 or 90 degrees.
Edge distance
The edge distance is entered here.
Calculation from the zero point of the selected surface
Position in X/Y
This function is activated if the edge distances in X and Y are to be entered manually.
Edge distance X
Here, the edge distance in X is entered. Only a negative margin distance or 0 can be entered. Positive values are not possible.
Edge distance Y
Here, you enter the edge distance in Y. Only a negative margin distance or 0 can be entered. Positive values are not possible.
Slotted holes in mutually offset rows (SHmo)
SHmo
Here, you can select the hole type for a slotted hole in mutually offset rows.
Hole length (l)
The hole length is entered here.
Hole width (w)
The hole width is entered here.
Diameter
Enter the diameter for the slotted hole here.
Longitudinal length (c2)
Enter the longitudinal length for the slotted hole here. The longitudinal length is the length in the X direction.
Lateral length (c1)
Enter the lateral length for the slotted hole here. The lateral length is the length in the Y direction.
Angle
The angle for the slotted hole is selected here. You can select 0 or 90 degrees.
Edge distance
The edge distance is entered here.
Calculation from the zero point of the selected surface
Position in X/Y
This function is activated if the edge distances in X and Y are to be entered manually.
Edge distance X
Here, the edge distance in X is entered. Only a negative margin distance or 0 can be entered. Positive values are not possible.
Edge distance Y
Here, you enter the edge distance in Y. Only a negative margin distance or 0 can be entered. Positive values are not possible.
